Is this normal after alighnment?

Just had an icon stage 3 installed with the rxt leaf pack. Had the truck aligned right after install and the numbers looked good. I noticed later that the cam adjustment on the drivers side is cranked all the way to the right but on the passenger side it’s closer to being in the middle.

I should note that after the lift & alignment I had about a half inch of taco lean so yesterday I adjusted the drivers side coil over just a tiny bit so the truck is level.

did they align it like this because it was leaning after the lift was installed? Do I need to take it back and get another alignment for the small adjustment I did with the driver side coilover?

truck tracks and drives perfectly strait down the road but 33s are expensive and I do worry about uneven tire wear. What do you guys think? Thanks!

 

Well what’s the alignment sheet say..? Did they not give you one?

 

What’s the concern with the adjustment cam?
If the alignment numbers are good, what’s the deal?
If you tweaked the ride height, it can mess with alignment numbers.

 

The alignment sheet will tell the story.