1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

CRANK POSITION SENSOR HARNESS 05 X Runner

Discussion in '2nd Gen. Tacomas (2005-2015)' started by Rawny, Jul 3, 2024.

  1. Jul 3, 2024 at 9:08 PM
    #1
    Rawny

    Rawny [OP] New Member

    Joined:
    Jul 3, 2024
    Member:
    #452675
    Messages:
    1
    Gender:
    Male
    Vehicle:
    2005 x runner
    I fucked up….

    So I had to pull my motor out a oil pan gasket repair & also to replace my clutch.

    I’ll get straight to the Point tho…. The harness for the Crank Pos. Sensor got yanked out of its connector. & that’s where I need help. Motor is back in & now not turning over. Note this motor turned over before I pulled it out.
     
  2. Jul 3, 2024 at 9:21 PM
    #2
    Dm93

    Dm93 Test Don't Guess

    Joined:
    Mar 3, 2015
    Member:
    #150066
    Messages:
    13,735
    Gender:
    Male
    Texas
    Vehicle:
    2014 DC OR 6spd 4x4
    Predator tube steps, Ranch Hand grill guard, Magnaflow CatBack exhaust, Toyota tool box & bed mat, 2LO Module by @Up2NoGood, Rearview Compass/Temp Mirror, Tune by @JustDSM.
    The engine won't run without a valid Crank Sensor signal so you need to fix the wires before it's gona run.
     
    Torspd and TnShooter like this.

Products Discussed in

To Top