4th Gen Glove Box Mod

Well peeps...its just as simple as a wee strip of tonneau cover seal smack dab in the middle of the glove box lid. Mission accomplished..takes up the slack.

 

Cool!

Yes there is slack but I haven’t heard it rattle yet

 

Been on some seriously rough washboard roads no rattle on mine…

 

I haven't had mine rattle either...figure it's a matter of time..so nip in th bud so to speak.

 

I watched a YT vid yesterday and they claim the engineer did that on purpose for when getting in if you bump your knee there is some play. I call BS put hey maybe as it seems they all have it.

 

Once Toyota gets enough complaints the glovebox lid will get deleted. That's the most cost productive route for Toyota.

 

I think I watched the same thing yesterday

 

Robmotive added something to his. I hit a fair bit of bumps and haven't noticed it bouncing

 

Glovebox is designed to move like that the rubber is spring loaded to absorb or cushion if you bump gour knee

 

Mine has slack but the spring is stiff. It’s not going to rattle unless you are doing the Baja 1000 at 100mph or something.

 

They all have it, the gap is consistent, and most importantly, all of these doomsayer youtubers have yet to actually post a video of it rattling around. Everyone complains about it but no one has actually put up proof of an issue outside of them pushing it up and down and going "SEE!? IT MOVES!".

 

Exactly

 

I'm going to add this to my list of complaints.
1. Too small
2. Too small
3. Too Small
4. Too small
5. Glove box spacing