What Have You Done To Your 3rd Gen Today?

I could not find a bungee cord, so I removed this it was not fun.
I removed it because I added this rci bumper, and my spare no longer fits.

 

I'm finally getting a decent sound system.
Why do tocos leave the factory with trash for speakers?

 

Mine seemed fine at this time, I didn’t really have the extra cash for them right now. I REALLY needed new pads though, they were way overdue.

 

Interesting feedback on pad/rotor lifespan. I'm at 52k. My drums are squealing like a pig at low speed stops. Probably just really dirty and need lube on the contact points of the backing plates. My fronts are still smooth when stopping. No shudder or warp feedback, but the truck does take a little longer to stop. Probably getting close to needing pads. I'm too busy to pull the wheels and check the pad thickness.

 

Are those 3 way coaxials going in front? Curious cause I see you also have the tweeters.

 

Just did the same.

 

what size / brand tire ? I have same bumper and 285/70/17 BFG KO2 and tire fits. Albeit very snug.


And FWIW was down there for a few years and recently got a flat. Tire was fine and no heat damage from exhaust etc.


hoping that helps as it definitely seems like it won’t fit at first but takes some profanity

 

Thank you, and the others, who replied to my post!
It turned out that the normal 6 spline key did work just fine on all the other wheels- it was just 4 or 5 nuts on the front passenger wheel that were jacked up. So, I didn't really need anything special, just replaced the lug nuts and all is well.

 

I did the same, last weekend. Also tossed in a new battery for good measure. It was the original and I just didn’t want to take any chances.

 

Finally installed the header yesterday

 

Hmmm. I use lots of profanity.

275/75/17 open country rt trail
I aired it down. It was rubbing on the pumpkin. I didn’t take it any further based upon the extra space the hitch takes up. The exhaust is chopped, and it felt like it was closer to the exhaust too.

 

Pssst. That’s not where they go

 

Damn. Little slow huh? Lately I’ve been trying to not let anything sit on the bench. Had to mount speaker brackets for some speakers the others day. But most everything gets here and I m trying to get it on immediately. Received my rear bumper, pulled the old one and slappped the new one on. Had to relocate the sensors and lights. Hardest part was pulling that off the old bumper.

now the replacement solar panel, and roof solar panel, I might sit on those for a minute

 

Just following the instructions https://media0.giphy.com/media/KBax...z&ep=v1_internal_gif_by_id&rid=giphy.gif&ct=g

 

They ARE "exhaust management pipes" ...

 

Clearly you can see the bolts aren’t torqued to spec.

 

Torque wrenches are a pain in the a@@.

 

I like the Grill, where di you get that made? does the letters light up?

 

Do you know if these are compatible with Tacoma's that don't have factory BSM? It's a feature I'd like to add.

edit: I guess these don't have sensors built in for BSM like the oem mirrors.

 

Are your mirrors Blue and over all how long of an install was it and did you have to wire any wires in/?