Installing fog lights

I am trying to install fog lights to my 2018 SR. I watched videos on it and it looks pretty simple and easy. I have removed the 3 screws that tighten the wheel well cover but I have a hard time to pull the cover open wide enough for my hand to reach in to the front to anchor the light and to put in that one screw to hold it in place.

Alternatively, can I reach in from the top under the hood to anchor the light and to put in the screw? Any suggestions are welcome. Thanks,

 

It's a simple job to remove the grill and then you can easily get to the fog light.

Two screws on top of the grille, two push pins on the sides, unplug the radar sensor and then a firm pull and the grille comes right out.

 

I swapped mine out twice just reaching straight down behind the headlights. Didn't have to remove anything except the 1 phillips screw that holds the factory fogs on.

 

Removing the grill and the air dams will make it easier. You'll still have to reach down there and pull the one screw. Then you will have to get back in there to adjust the height. it can all be done from the front of the truck. No need to access from the wheel well.

 

Thanks for the instruction. I will give it a try and report back.