Camshaft position sensor, CEL, P0348

Hello everyone. I have 2021 tacoma off-road. Yesterday I started it up and immediately got a check engine light. After a little investigation, I found that the camshaft position sensor( bank 2) had been chewed by rodents. The fun one to access that is under the Air Intake Surge tank. I believe the sensor itself should still be fine. But I need to replace or re-wire the clip that attaches to the sensor. The little f@#kers chewed it right at the clip so I can't just splice the wiring back together.

This is a possible replacement I found from Amazon. Is there a better one that people know of?

Thanks!!

AUTO OCCASION Camshaft Position Sensor Connectors 3 Wiring Compatible with Lexus Scion Toyota 2CAM0057

https://www.amazon.com/dp/B0CTCKZ431?ie=UTF8&sp_csd=d2lkZ2V0TmFtZT1zcF9waG9uZV9kZXRhaWwp13NParams

 

You are the 2nd this week.
actual part number is 90980-12353.



Here is wiring diagram

 

Thanks for the part number and diagram. Definitely helps!

As this issue is only a sensor, it shouldnt cause any further problems or damage with the vehicle if I drive it, right?

 

No, won't cause any issues. ECU usually defaults to a base tables and won't advance/retard cam angles, etc.
Make sure to pay attention to pinout and wire colors. Don't use any types of butt connectors, solder wires instead.

 

Will do. Thanks for help an info!

 

Thanks again, for the info. I rewired the part myself without taking off the air intake. It was a bitch but i felt I saved a lot of extra time and money.

1 thing I did notice, because of the check engine light, the truck did have a loss of power.