Is it fitting for a Limited to get dual Limited slips?

Finally got around to installing the spindles with gussets and added some jd fab uca’s since the spc’s needed new X-axis bushings and the ball joints were worn. I probably should have gone with the .25 uca’s instead of the .75 as I lost a little clearance at the back of the fender from where the spc’s were setup.

 

Will you be selling the SPCs? Been trying to find a worn set so I can rebuild & powder coat.

 

no they are going back to Spc for warranty replacement.

 

Well I joined the canopy crowd. I was running out of room under the tonneau cover for all of our rc cars and the ramps. This should help that situation.

 

Finally have a reason to get these @MESO headlight trim plates installed.

 

Scored a deal on a C4 Fab hybrid and Warn VR Evo 10S. Got the water pump for the blower moved and mounting the control box before I take a lunch break.

 

Was able to reuse the water pump bracket and relocate it up onto the trans cooler mount to get the pump up and out of the way of the winch. I had to bend the bracket to make it work but better than having to cut up the coolant hoses. Took it up around the block just in time for ups to deliver the fog light brackets from @memario1214

 

looking good man!

 

Thanks, we have had tons of fun with it. I’m really getting the itch to do more but we are looking at a new house that will tie up all my discretionary monies for a while.

 

We need more photos of your truck!! Been too long and I'm going a very similar route to yours. I have 16x8 +0 TE37x in bronze waiting on the new KO3 to be released and about to order King suspension and the same Alucab Expedition.

 

life has been keeping me busy. Here is a shot from last weekend where I was hauling some lumber up to our campsite to build a patio and gazebo

 

What a great setup. I am really loving the wheel setup you went with against the blue. Love the bumper, makes me realize I need to get a day off to weld mine and install. Great build, ready for more.

 

Went full on mall crawler status today by adding some bfg KO3’s

 

Trucks getting some additional mods. Ordered the jd fab lower control arm mounts and skid plate. Won’t have time to mess with this stuff until after the holidays but couldn’t wait to open it up and take a peak.

 

Whelp I’m a f***ing dumbass. Fence gate swung closed as I was backing in. Saw it move and by the time I could hit the brakes I heard the crunch.