Need Assistance Finding Wheels From Other Makes & Models That Fit My 2014

Hello TW members,
I'm a NOOB/FNG and this is my 2nd post, 1st being my introduction.
Many of you are probably going to say "Not this question AGAIN!", but
after searching the internet and not finding what I'm looking for I elected
to ask for help from the TW community. I probably wasn't looking in the
right place.
I just purchased a 2014 Tacoma standard cab 2 wheel drive and it has the
stock steel 15 inch wheels, which are dull, beat up, and frankly not very appealing.
My 1986 had the same situation, but I found out that many Jeep models with standard OEM
wheels would work on Toyota trucks, which it did in my case.
Fast forward to my 2014. Does anybody know which makes and models OEM wheels
will work on my 2014? I probably want to go to 16 inch or higher. I'm finding out that
since my 2014's wheels are 5 lug/hole that it's limiting options.
I believe these are the current spec.'s on my wheels:

• Center Bore / Hub Bore: 60.1 mm
• Bolt Pattern (PCD): 5x114.3 (5x4.5)
• Thread Size: M12 x 1.5

Any assistance from forum members would be greatly appreciated by me and my Taco.

 

Try the 5 lug forum. Our trucks are 'different'.

1st gen Highlander wheels are a 16" fit.

I chose to collect 'spare tire wheels', clean, rattle can and add SS trim rings for a old school look. Guarantees a perfect fit.

 

Many Thanks Clearwater Bill!
The SS trim rings are just the right touch.

 

Your specs are spot on. Old Ford and Mopar ran the same 4.5"x5 wirg rwd offsets not sure of the center bore dia.. The xrunner runs a stock 18x8 with 33mm offset. I have a nice set of 17x6.5 w/ 45mm offset 61 center bore "limited" wheels that came off off my 06 Sienna for sale. I'm in the central valley, Ca. Area.