Relentless Fabrication Rock Sliders for Double Cab

These are Relentless Fabrication weld-on steel rock sliders for a 1st gen (1995-2004) toyota tacoma double cab.

Looking to sell locally in the Rhode Island area. $600. PM me for additional details.

I purchased these from relentless fabrication for my 2002 tacoma double cab years ago (Relentless fabrication no longer sells these, and they arent on their site). I primed them, bedlined them, and put them in storage (they could use a rinse). I never got around to installing them, so the mounting surfaces are still fresh for welding. The last image is an example of these kind of rock sliders installed on a 2nd gen tacoma (Its not my truck). I recently sold my truck and no longer need these.

Below is a copy/paste product description...

"Key Features:

USA sourced 2x2” square x.120” steel tube inner structure and 1.75” x.120" DOM round outer tube structure.
oversized 3/16” thick CNC cut gussets and frame plates.

Outer rail sits at a 15deg up angle as standard.

Weld on mounting Only

Installation is weld-on. Line up the appropriate side slider to the frame, position it between the wheel wells in the desired location and mark where the mounting pads line up on the frame. Sand off the paint from the frame in those locations and on the edges of the slider mounting pads. Once clean and ready to weld, hold up the slider with about 1/2inch clearance between the top of the standoff tubes and the pinch weld along the bottom of the cab, then tack in place and fully weld around plates. Paint the bare metal after it has cooled. If you want the slider to sit higher, the pinch weld can be marked where each slider leg is positioned and the pinch weld can be cut vertically and folded back. If this method is done, maintain the previously mentioned 1/2inch clearance around the legs, front, back and top."

 

Bump

 

Bump

 

Bump

 

If you weren't 2000 miles away these would be on my truck already.

 

Bump

 

Bump

 

Bump

 

Bump

 

Bump

 

Bump