no start 2007 v6 4.0 Tacoma

just rebuilt the engine drove it probably 5000 miles since then had to leave for five months.
started it up when i got back and ran fine only issue was the gas pedal had zero response.
parked it in the shop and now no start. when i try to start it acts like i have the pedal floored and goes straight to rev limiter. I'm assuming i need to change throttle body. anyway to test those?
related codes are: p0113 p2112 p2111

also at one point i had a very detailed tear down of this truck from this site and now cant find it. any ideas where to look? totally new to this site first time using it

 

Have you pulled the air filter box off and checked for anything stuck in the throttle body holding it open?

Since the truck was sitting for an extended period it wouldn't surprise me if a rodent didn't build a nest in there and chewed a hole through the air filter.

 

yes have it all apart throttle body is stuck close and wont budge.

 

If that's the case sounds like you need a TB, I'd go OEM if possible (not Amazon/ebay "OEM") or if not a used one. Aftermarket ones are hit or miss.

 

Stuck open and stuck closed? Revs to moon, but throttle blade stuck closed? Are you trying to move the throttle blade with the key on?

Take off the throttle body and snap a pic of the backside of the blade, sounds like it needs a good cleaning.

 

so brand new throttle body put in runs now but 0 throttle response any ideas?

 

Check the ETCS fuse (10A) in the underhood fusebox, being the old TB was stuck it may be blown.

If it's good then you will need to see what code(s) you have.