Anytime Camera Install

Anyone here or anyone know who would install for $ in So Cal? How much for the install? 3rd gen TRDOR DCSB.

 

"Any" Stereo shop should be able to do it easily...Since it's plug and play I don't see them doing much of a hack job.
FYI The main harness on either side has at least 1 extra nipple you can snip off and feed wire thru.
What area of So Cal are you in?

 

Looking for someone that has done this several times b/c stereo shops tend to charge more than they should b/c they've never done one (which I understand). I'm in 818 area. Know anyone?

 

You mean adding the anytime front cam add on, right?
The fact that 3rd gens ran from 2016-2023... That is not a good excuse for any "Stereo Shop" to give.
They've probably done installs on at least 50 3rd gens by now.
I've done audio on at least 5 and I was at a very low volume non retail mostly high end/fab shop for the last 4 yrs.
They might not be able to give you the exact amount of time, but should give you a good estimate.
I would say 2-3hrs Max!
Only spot I know close to that area that I would let touch my vehicle is Agoura Autosound.
I can do the install, but I'm in North OC and it might not be worth your time to travel out this way.

 

Thanks. Don't mind if going to north OC if you're confident on install. PM me please with your quote if available.

 

It's super easy. Ground wire to the front 10mm inner fender bolt, run the others through the firewall under the dash and plug into the back of the radio. Radio has 2 10mm bolts holding it in. Depending on what lines you want showing and the orientation of the camera view you snip a wire or two in the instructions.

Give it a whirl. If you get stuck post a question or hire out then.

https://www.youtube.com/watch?v=NyT9IqiW9AM

https://www.youtube.com/watch?v=6GQICf81Nt0

https://www.youtube.com/watch?v=SJ4mhopxuPY

 

Which wiring harness is recommended for this?