Oil Filter Housing Fix?

Tried to complete a DIY oil change this morning. Even with my 25 inch breaker bar, the only thing I managed to move was this nickel-length hunk of the filter housing. Any ideas for an in situ repair that might hold for at least a few miles?

 

^Is the filter housing now leaking?

 

If you made a crack or a hole in the housing I wouldn’t trust anything but a new filter housing.

 

Not leaking now, but that's because all the oil in it leaked or drained out...

 

Me neither.....The problem is that I need to get to someone who has enough torque to install a new one...(Don't know what the heck the dealer did to get this one so tight....)

 

Get you a Motivx Filter Wrench.

https://a.co/d/cbn310c

 

Yeah, I've seen these recommended. Should I just ignore the red message from Amazon that says "This product does NOT fit your 2020 Tacoma"?

 

Yes, they have not updated there years put in 2018 Tacoma 3.5 and it will show that it fits. It will not break tabs but with one as tight as yours use the 24mm socket and a breaker bar.

 

If you don’t have a 24mm socket order this one.

$9 Capri Tools 24 mm Shallow Impact Socket, 1/2" Drive, 6-Point, Metric

https://www.amazon.com/dp/B077VWH2BC

 

Yeah what do they know. Reading down in the description, it said that it fits the 3rd gen tacomas

 

Thanks. I just wish to heck they could ship that sucker overnight....

 

Start a thread requesting help in Regional Texas they just might be a member near you with a Motivx wrench.

https://www.tacomaworld.com/forums/texas.46/

 

25" bar is alot of torque. Are you sure you did not get disoriented which direction to lose the cap? Check markings on the cap which direction to turn while lying on the floor

 

Get the aluminum filter housing

 

Where in Texas are you located?