1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Metal dust on crankshaft position sensor?

Discussion in '1st Gen. Tacomas (1995-2004)' started by 2R-STEEZ, May 16, 2025.

  1. May 16, 2025 at 9:22 AM
    #1
    2R-STEEZ

    2R-STEEZ [OP] Active Member

    Joined:
    Jan 9, 2024
    Member:
    #441318
    Messages:
    31
    Gender:
    Male
    Vehicle:
    96 Tacoma 2.7L base
    Recently I went to replace my crankshaft position sensor in an attempt to solve my crank no start issue when I noticed it had what I recognize as magnetic spikes on it.

    I rolled the paste on my fingers and couldn’t feel any pieces of metal but I feel that it must be metal dust to look this way.

    how concerned should I be?

    IMG_1187.jpg
    IMG_1188.jpg
     
  2. May 17, 2025 at 6:26 AM
    #2
    1 Limited Toyota

    1 Limited Toyota ISO XRunner body kit complete or pieces

    Joined:
    Apr 30, 2023
    Member:
    #423667
    Messages:
    1,049
    Gender:
    Male
    California
    Vehicle:
    08 XRunner
    slowly erasing past owner hacks
    No issue at all. Normal road dust pick up. Just brake clean it off. Usually worst itll co is set a code
     
  3. May 17, 2025 at 3:00 PM
    #3
    2R-STEEZ

    2R-STEEZ [OP] Active Member

    Joined:
    Jan 9, 2024
    Member:
    #441318
    Messages:
    31
    Gender:
    Male
    Vehicle:
    96 Tacoma 2.7L base
    I appreciate the response. I was a little spooked over here after going down a rabbit hole haha
     

Products Discussed in

To Top