2023 TRD Sport OEM LED Headlight Harness

Where can I get a harness to install my OEM LED headlights? I see FBC is no longer making them.

Can you advise on who can provide them?

Thanks!

 

^There are like 50 listings on eBay, e.g. https://www.ebay.com/itm/394998970213

I suspect this is part of the reason FBC got out of the business - it has become too commoditized.

 

I got one of those and it is not working quite right. So I assume I need a better quality harness...

 

Can anyone tell me if this is correct?

 

You suspect wrong. eBay had tons before.

https://www.tacomaworld.com/threads/trd-oem-led-conversion-harness-diy-info.700623/

Details there.

 

This is a pic of the harness I have:



I connected the terminal manually one at a time and found out 3 wires need to be moved.

The blue wire needs to move to the green location. The green needs to move to the white location and white need to move to where the blue was.




I have removed pins from connectors before but I'm not sure how to remove the pins from this 6 pin connector.

 

pop out tpa from the front by first prying from the side where the tab pushes in with a small flatblade to push it up, then from the front edge as a lever to pop it off entirely.
Then same 1.5mm flathead can pry back the tabs allowing you to retract the wires from the back.

The way it's pinned right now, black is ground, white is DRL, blue is park, green is turn, red is high beam, brown is low beam. Kinda looks right to me.

OEM wire colors driver side are:
solid white == high beam
red == low beam
tan == turn
green == drl
ping == parking lights
white w black stripe == ground

 

Thank you. I thought before I damage them I will return them and get a new set elsewhere. I appreciate the help.

 

These cheap harnesses are junk. I got 2 sets and they were not wired correctly!

 

The photos look correct to me. If you post a clear shot I can eval the new ones.
They don’t work at all or only partially ok?

 

Here are the 2 new harnesses that do not work:





As you can see the red and green are not the same for each harness.

 

As you can see in the first harness, the green an blue are swapped.



If I could de-pin it, it could be corrected.

 

I was able to open up the first harness connector. All it needed was the blue and the green to be swapped. Works great now. Thanks for all the help!

 

Thanks, this was a big help!