What Have You Done To Your 4th Gen Today?

We only need to have the actual prices listed in our wills so they can get close to full value when we die, or we can all be bros and let each other buy it for what we told them it cost.

 

I saw this post last night and today checked my Lasfit LED switchbacks. Same problem. Mine glow fine when white but remain white (and don't flash orange) when turn signals are on. This is a big safety hazard. Lasfit needs to do a recall. I'm past their 45-day warranty but will raise hell if they don't give me my money back.

 

They make decent floor mats? But their bulbs are hot garbage!!

 

I just added a thread (Defective Lasfit LED Switchbacks) on the main 4th gen page. Any recommendations for an LED alternative to the Lasfits?

 

Just get the ambers. The switchbacks are the only ones that seem to be having the issues.

I’ve had mine over a year. And I run them as DRLs

$55 LASFIT T3 7440 7443 LED Turn Signal Amber Bulb CANBUS Error Free New Extremely Bright 7444na Light 7441 7444 7440NA W21W WY21W with Built In Resistor Anti Hyper Flash, Only For Standard Socket(2pcs)

https://www.amazon.com/dp/B0C8M81CY1

 

I second that recommendation. The ambers are good. My switchbacks have been in the box since October.

 

I am a hater of white lettering on tires suffering PTSD from the seventies. That is the first photo where white lettering on tires make sense to me.

 

it really is great, isn’t it. so far the spooling hasn’t gotten old whatsoever.

 

time to get those stock tires off and run some ATs!

 

Installed bed step with the SXTH Element bracket

 

In your opinion, would your tailgate spoiler interfere with a soft tonneau cover in any way?

 

Photos of the dump exhaust??

 

Back to the BYND4x4 camper life.

 

I have a hard tri fold cover and it doesn't interfere. The tail gate protector tucks under the tail gate cap.

 

Dam that looks good

 

anyone install seat covers on the front seats that have heat/cooling option? thinking about it but not sure it would negate the options

 

Build thread started.
Done for now - summer trips ahead.

 

gave it its first bath, then

 

Not who you quoted, but here’s mine:

 

Finally installed my C4 Fab front winch bumper. Extremely pleased with this bumper. I only had three issues with this install. First, my old Warn XD9 with the 6hp 9.5XP motor didn't fit the cradle. The motor was too long. Fortunately, I still had the original XD motor, and it fit. Tight, but it fit. The second issue was a minor one. The bumper comes with a "bridge skid." The 1/4" cap screws it comes with were too long, and ran into the crossmember. I cut them in half and solved the problem. The third issue is I now have a front sonar error.

I contacted a buddy that works for Toyota (corporate) on the front sonar sensor. I'm getting told from him, and other sources, that the battery should have been disconnected before unplugging the grille connectors. If this is true, it would be nice of all of the aftermarket bumper manufactures would put that in their install instructions.