Fox 2.5 Factory Race Series DSC part # (O-ring)

Does anyone know the part # to this o-ring that goes around the high speed compression knob?

 

Bump

 

Since you used @AccuTune Offroad pictures, did you reach out to them and ask?

 

I haven’t but thanks for tagging them. I hope they can reach out, I figured someone would know.

I recently washed all my old fluid film off the truck and found all 4 o-rings on the ground. They were all too big to fit back onto the compression knobs. I Ordered these (below) but they ended up being the wrong ones, again too big.

https://www.polyperformance.com/fox...990&gbraid=0AAAAAD8zTIKSqolrjLDo1AK_sqYwfQG6a

 

You likely don't need a Fox part number for that. Just measure it and buy a generic one from a hardware store. This site shows how to measure it, you can also buy from them. https://www.theoringstore.com/store...tBdo1nnifEMzmSNfbXD14akJ5vZ0sLeXXbUXzWwHB7KX1

 

The part number for the O-Ring is FOX-029-05-029.

We have them in stock and ready to ship!

 

If the old rings have swelled, stretched, etc, that measurement will not be correct.

HOTDAMN!