DIY: Fuel Filler Relocation for Fiberglass Bedsides (Glassworks) Write Up

Yikes, I knew Cali was pricey but wow. You could try this:
https://toyotaparts.mcgeorgetoyota.com/oem-parts/toyota-filler-hose-7721335370

 

Yea I saw that it’s gonna take a little to ship it tho I’m debating on just going and getting fuel line to make my own

 

Let us know how it goes!

 

My first 4 runner hose deteriorated on the inside blocking fuel from going in, only lasted like 6 months. Bought it new, got a replacement and still good almost 2 years now

 

UPDATE like ^ SB said I replaced the 4 runner fuel neck with a new one it had deteriorated a little on the inside and was just weak overall And was also kinked a little the new one isn’t kinked for now and I was able to fill up

I was able to grab the part from my local dealership through a friend discount for $41 yewwww

 

How is it holding up? I finally found a thread on this. I’m trying to do this in two weeks

 

Everything’s held up so far for me

 

Does anyone know if this works for 12-15 or if they are different?

 

Yes it does work for 12-15

 

Sweet. I went to JD Fab Shock relocates and 62 Swap and my shock mounts pushed my filler lines back about an inch or two and so my filler is just shy of reaching the OEM location.

 

It might give you more than an inch or to I would measure both pieces and check

 

Looks like the hose is discontinued. Called a few Toyota dealers and they don’t have it anymore. Ordered online and the order was voided. I ordered on Amazon but it’s been preparing for shipment for weeks now. Don’t think it’s going to ship. Anyone have any other ideas or an extra hose laying around?

 

Technically you could use any type of fuel hose large enough to fit over each end and use clamps you just want to make sure you have a almost perfect fit around each end

 

Anyone got any suggestions for a fuel hose?

I have just discovered this issue..

 

Amazon has a few qualit

Go to oreillys and get a length of gates fuel rated hose. I actually got this oem filler awhile back, crazy to hear its discontinued

Its currently just zip tied as I spent dozens of hours getting the fuel door just right and trimming the oem filler enclosure to fit.. its still eh.. I like the rubber seal in the original post. I tried to find this thread for a long time now to reference the part number.

 

LEGEND.

Will do.

 

Alright,

Got a 1 inch diameter fuel hose from oreilys, no luck fusing it sufficiently to the pre exisiting outlet. Tried using hose clamps, the 1 inch hose is fine for the fuel tank end, but I can’t compress it down enough for the filler neck end.

any suggestions?

 

Caved and ordered one of these,

going to see if I can make it work.

 

Any tips on cutting the evap hose free?

 

Got mine done,

The part identified is no longer available. So I got a close enough replacement and Jerry rigged it with the stock hose.

No leaks or codes so i guess success!