What Have You Done To Your 2nd Gen Tacoma Today?

Driver's side there was some slight misalignments. I used my dremel to widen out some holes. Fasteners are subpar but they do send extra fasteners so I guess that makes up for it? I haven't test drove it yet, but Im thinking there may be some slight rubbing on the microflares going on inclines but I can trim it accordingly. All in all, I don't regret the purchase.

 

I just installed them on my 4runner with zero problems but on the inside hole I did use a slightly smaller plastic rivet from a set like this

$11 GOOACC - GRC-33 240PCS Bumper Retainer Clips Car Plastic Rivets Fasteners Push Retainer Kit Most Popular Sizes Auto Push Pin Rivets Set -Door Trim Panel Fender Clips for GM Ford Toyota Honda Chrysler

https://www.amazon.com/dp/B07L6FJGR4

 

Curious to know if you have a recommended shop in the Bay (PM works) knowing I have some SPC in my case I would like to mount.

 

Took a couple pictures

 

Replaced all for brakes with new hardware, SPC ball joints, lower ball joints, axles, wheel hub bearings and other front suspension wear and tear stuff that haven’t been replaced since buying the truck in 2009.
It was supposed to be just the dang brakes and SPC upper control arms ball joints but it all went down hill once we started inspecting stuff when we got it on the lift…lol
Honestly I was hoping to resolve this intermittent odd creeking noise in the right suspension when hitting bumps . But nope. Need to investigate that more.

 

Old man and I today:
Replaced all the spark plugs…I doubt they’d ever been done
Cleaned the mass air sensor
Cleaned the throttle body… clearly had never been cleaned before.
Repainted the wiper arms.
removed the old bedsides.

installed the new fibreglass sides…but I haven’t fully bolted it all in as I couldn’t get the bed loose. Will have another attack at it tomorrow. Also learnt the fuel hose isn’t long enough.. so I’ll need to think up a strategy. It’s booked in to get resprayed from Saturday.

 

did you end up doing 2k clear?

 

Got a used bed mat, everyone recommended so I had to see what the hype was about. Let’s see my cooler try to slide around now.

 

Looking forward to installing these tomorrow!!

https://geartechcustoms.com/shop/ols/products/2nd-gen-engine-splash-guards

 

I just ordered these too! Hope the fitment is nice as they were not cheap

 

That looks like an “Undercover” bed cover. I have one and love it, it’s a bit bulky to move as I have the 6ft bed.

 

Good eye. Love mine too, i usually grab a second to help me remove/install. Always keeps my detailing equipment protected .

 

Where in the bay are you located?

 

Yep.


Seems to have laid just fine

 

Truck is up and running! 4.88 gears and rear LSD. Huge thanks and appreciation to @blackgen2tacoma!

4.88 gears do feel nice paired with 35’s and the S/C. Seems to move the truck with ease and effortlessly. Can’t give a full review since I’m in the break in period.

On its way home

 

Painted my trd ifs skid black so it blends in a little better. Plus pulled the trigger on a new pair of JBA ucas.

 

Sound deadened my back wall and damn, shoulda done that sooner. Used Resonix products.

CLD tiles in progress.


sound mat


finished

 

Drilled a hole in the shifter and filled it with JB Weld.



Cleaned up most of the slop

 

Tell me about the molle panel please…

 

https://underlandoffroad.com/products/underland-offroad-rear-seat-molle-panel-2005-23-toyota-tacoma