Enkei RPT1

They're going to be really close!

 

16x8 with a zero offset? They are close, probably 3mm of clearance

 

Mine are indeed 16x8 with a 0 offset

 

Hard to tell how thick your weights are, but mine clear fine. Edit: saw your meant weights, not caliper clearance

 

Smaller ones are 1/4oz, taller ones are 1oz

 

I definitely have the 1/4 oz, but you should be fine. May be hard to tell in these photos, but the caliper is more on the center of the barrel. If the weights are as far outwards as possible, they won't be close. You can see my rear weights have plenty of space, and my father front weights should go where my finger is. Assuming it's close enough to the face of the wheel, I don't think you will have any issues

 

Thanks for the pictures! I’ll see how it goes and make a follow up post when they’re on tomorrow

 

You should be okay. My weights cleared.

 

Follow up post here, I was just overthinking it, they cleared just fine!

 

Hey man, new to this forum so not sure if i'm doing this correctly. which center bore size rpt1 did you go with?