Light Racing UCA bushings?

Scott is fucking hard on his truck

 

Mine had a little less play but quite similar. Also play in the ball joints.

 

I will say SPC has been good to me. All I had to do was pay 200 per arm, refunded when bad arms were sent back. They took care of shipping both ways.

I just hope these last. The BJ boots appear to be a better design and quality.

 

bullshit
do i use my truck sure but i do not abuse it in any way.....
do i wheel it yes jump it no ...drive like a dusch no
so f u cupless wonder

yes i just had the ball joints replaced 6 months ago
here is that video
http://youtu.be/qQcD1tlR8C0

i hope they are good to me gonna call today

 

Wow, dunno what version I had on the 05 but left them on when trading in for the 08. I will consider this another successful problem avoidance with the swap. Good luck with this............

 

Didn't you use some rubber eating grease ?

At least that's how it sounded in the NJ Tacos thread .

 

noo grease will not eat the bushing......
mobil 1 syn....

 

Just curious if you left the upper bolt lose, then torqued it after there was weight on the wheel?

 

ye3s sir been on my truck almost 2 years now.....

 

Ok just wonderin. Ran mine for about 3 years before I swapped lifts. They are in great shape except for the light surface rust. My likely the offroad too

 

Yes for me as well.







Your BJs are much worse off than mine though. Then again mine lasted less than a year.

 

did any of you notice squeaking after you had installed these.

i have some noise now from what i would imagine would be the uca

 

Not really.

 

I've tried getting some good pics of the tears in mine, but they always turn out crappy, and you can't really see anything. They look like the start of what happened to Max's UCA's. Hopefully they can hold out till the Spring for the new ones.