Alright I need some audio people help

I have a Hifonics Brutus BRZ1200.1D Brutus Series Monoblock Class D Car Amplifier and I need to run two S10L5 Kickers. The kickers are 450 rms so I need to run them at 2 ohm so I am pretty sure I need to wire the kickers in parallel. I need some wiring help, If someone could write up a diagram that would be awesome. I also have an 300 watt amplifier with two polk audio 100 rms speakers I need to hook up in the mix or do I hook them up separate? This is my first somewhat big system so any help would be much appreciated.

here are the mono block stats

RMS Power Rating (@ 14.4V):
4 ohms: 450 watts x 1 chan.
2 ohms: 900 watts x 1 chan.
1 ohm: 1200 watts x 1 chan.
MOSFET power supply
Wired HFR-3 remote bass level control included
LED power (green) and protect (red) indicators
Variable Bass Boost (0 to +10 dB bass boost at 45 Hz)
Mono channel operation
Preamp RCA outputs to daisy chain multiple amps
4-Way System Protection circuitry (thermal, overload, speaker short and DC protect)
Heavy duty aluminum alloy finned heatsink for maximum heat dissipation
Silver-plated unbalanced RCA level inputs
Silver-plated molded screw terminals
Input sensitivity:
Input Level (Unbalanced): 0.2V-9V
Input Level (Balanced): 0.04V-18V
Variable low-pass filter (35-250 Hz, 24 dB/octave)
Subsonic filter (15-35 Hz, 24 dB/octave)
Phase Shift: 0-180°
Damping factor: >290
Frequency response: 35-250 Hz
CEA-2006 compliant amplifier
Dimensions: 14-5/8"L x 9-1/4"W x 2-7/16"H
4-gauge power and ground wiring is required for installation

And here are the kicker stats

10-inch Solo-Baric L5 subwoofer
Vacuum-formed, ultra-rigid design with vented 360-degree back bracing
450 Watts RMS (900 Watts peak) power handling with 2-ohm impedance
24-100 Hz frequency response

 

If those are single voice coil (2 ohm) subs, you cannot run them at a 2 ohm final load.

You can wire them down to 1 ohm, or to 4 ohm final loads.

http://www.the12volt.com/caraudio/woofer_configurations.asp

 

I believe the are dual voice coils

edit: They are dual voice coils, thank you for the link, super helpful.

 

Now I need to know what kinda of in line fuse I need and the gauge the power and ground have to be. I know the speakers have to be at least 16 gauge.

 

bcae1.com

Scroll down to #16 on the right side.

 

sweet! I think I have just about everything I need!

 

I'd use 14g at the very least. I ran 12g in my truck.

 

depends on length. That page has a calculator to see loss in voltage, watts, and volume in Db loss.