I think Ive got it, except for one thing.

Ok, Ive searched through the forums and Ive not exactly found what Ive been looking for. Im going to be lifting my truck with the OME kit, (885's, 1/2" top plate spacers [both sides], and a 1/4" spacer on d. side to correct lean). Im thinking that will be around 3" on ac. cab. But for the rear I was going to use the icon progressive aal pack instead of the single aal.

The icon aal says it will give 1.5" of lift in the back. With the OME kit going around 3" up front and the 1.5" in the back will I be sitting level?

 

Measure where you are at now, add those number and shank you have your answer

 

Never mind the "shank" autocorrect fail

 

I assume you have a 2nd gen? Do you have the TSB leaf pack? I got 885s with 5100s in front that gave me 3.25" and in back I had the leaf spring TSB with a toytec 1.5" aal and sat almost dead level with the front no more than half inch taller

 

Yup 2nd gen and no TSB. I'll measure it all out tomorrow and see how that ends up. Thanks for the quick responses guy!

 

I would install the 885's w/o the spacer on top and the 3-leaf AAL and see.

 

The AAL gives you 1.5" of lift without the overload leaf. If you put the overload leaf back in, you actually gain 2" of lift without compromising ride quality one bit.

 

If your going that high dont forget to add new uca's

 

I'd run the 885s with taco lean spacer first. You might get 3" of lift in the front on an AC.