installation help

I want to install these brand new spyder halo LED lights on my 2006 tacoma, however, im not sure how to wire this correctly to my truck, or maybe i need additional wires/bulbs?

 

anyone help me out with this?

 

You will have to use your imagination on what you want hooked up to what. The lo beam and hi beams will be a direct plug in to your stock harness.
Your turn signal and sidemarker will also be a direct plug and play

Now for the halos and angel eyes, you will have to T-Tap (cut and solder, however you prefer to do so) into your running lights/ lo beams/ whatever you want to wire them into. Or wire them up to a custom switch so you can turn your halos and/ or angel eyes on and off whenever you want.

 

ya i'd have to figure out that part for the halos and angel eyes, cuz i did hook em up to my truck yesterday with just the plugs and only those few u mentioned worked... idk what to do with the other wires for those halos and angels

 

Try looking up the orange county thread in the socal section. Im sure someone can help you out.

 

They are a pain in the arse to figure, CarID has a good plugNplay version for like $600 though.

 

I ordered a different but similar pain of halo headlight and it was a direct plug n play

 

This is pissing me off so much lol I just got em and ihave the nxt two days off! I wanna put em in! Lol

 

It's all plug n play, angels and led just plug them into the parking lights thats all

 

use this:

 

my brother works there =) hes basically a manager on the technical support team but since he leaves early to go to school at night they couldnt actually promote him because he couldnt close the place at nigiht

 

i think ima just have some one help me do it lol, probably safer that way

 

Call my buddy that I told you about in the message I sent you

 

actually they are $234.60, I bought them there full plug n play
http://www.carid.com/2007-toyota-tacoma-headlights/spyder-ccfl-halo-led-projector-headlights-315164.html

 

if yours are like mine you have to splice the 2 short black wires to the long black wire. they are all 3 ground wires. ground the wire that you spliced the other 2 wires to. and then splice the 2 short white wires to the longest white wire which is your power wires. then you splice those to your relay switch wire which is a green wire that runs to your corner light bulb. then put it all back together