will 35s fit

I just bought a 1.5" bl on top of my current 3" suspension and have 33s on there now. I got the bl to get bigger tires and was planning on gettng something like a 295/70/r18 or a 305/70/r18 but now i found 35/12.50/18 grapplers with good amount of tread for $75 a peice. What mods would i need to do to run these. I don't want to cut any of the body or my flares.
Any advive is accepted, thanks.

 

im not 100% but i think if you stuff the tire you will have ur fenders eaten.

Get them and make them fit

 

if i cut out the inside of the flares they would scrub bad you think?

 

4.5" of lift, go for it and cut what gets in the way.

 

i cant vouch, but for what i have read and all that on full stuff you will eat the fender cause the wheels stick out so far. People have cut out up to 3 inches of the flare and that helped, but I think they rub a tad here and there at full stuff

Will have to cut when you get them. Some times you cant pass up a deal.

 

you'll have to chop the cab mount for sure and some of the flare, you probably need to beat back the pinch weld as well.

edit: I did a 1.25" body lift on top of OME 885x springs with 5100's and didn't have to completely cut the fenders. I did have to trim the plastic and metal portions of the fender near the cab mount.

 

I have the km2 on 35s with a 6" fab tech lift and they rub on the inside on tight turns so doubt they would fit.... Runs on the frame too so had to cut and re weld

 

by chop the cab mount, what are you refering to. And also about beating back the pinch weld.

 

Those are wide tires!
If you really want them trimming will be required.

 

yeah thats what i was worried about..

 

pinch weld b4




After.. (cab mount is practically gone)

 

is your suspension 3" all around?

 

yes