1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Rim selection for 285's

Discussion in '1st Gen. Tacomas (1995-2004)' started by 808DAKINE, Jun 26, 2013.

  1. Jun 26, 2013 at 2:12 AM
    #1
    808DAKINE

    808DAKINE [OP] Well-Known Member

    Joined:
    Apr 23, 2013
    Member:
    #102692
    Messages:
    182
    Gender:
    Male
    First Name:
    Kai
    Lahaina, Hawai'i
    Vehicle:
    01 Taco
    Cold air, Sounds, lift, lights, exhaust and a canoe!
    Aloha guys, sorry if this is redundant, but I have a question about my future

    setup before I pull the trigger. Does anyone foresee any problems running:

    Mickey Thompson Classic Locks.. 16 x 8 6 x 5.5, 4.00 backspace with a offset

    of -12 hub bore with 285x75 r16 Toyo m/t on a 1st gen Tacoma with a OME

    3'' suspension lift & a 3'' body lift?

    I am mainly concerned about the back spacing, and if 4.0 is ideal.
     
    Last edited: Jun 26, 2013
  2. Jun 26, 2013 at 6:00 AM
    #2
    tacomataco2

    tacomataco2 A dude

    Joined:
    Nov 27, 2012
    Member:
    #91944
    Messages:
    2,218
    Gender:
    Male
    Mass
    Vehicle:
    15’ ACLB
    Some of this Some of that
    You'd only need a 1 inch body lift worst case, try not to run body lifts though.
     
  3. Jun 26, 2013 at 6:10 AM
    #3
    monstertaco12

    monstertaco12 Quack Addict

    Joined:
    Apr 25, 2012
    Member:
    #77636
    Messages:
    339
    Gender:
    Male
    Louisiana
    Vehicle:
    2012 Taco TRD Off Road
    There shouldnt be an issue with that. I have basically the same setup but for my 2012 and no body lift
     

Products Discussed in

To Top