Raising the front end 1"

2010 ccsb. Is there a simple product out there similar to the rubber doughnuts used on my Chevy to raise this front end an inch or so without messing up the ride or suspension?

 

Besides spacers you could always get Bilstein 5100's for up front and have them set to the .85" setting.

 

Not familiar with those but I'll do some research. Thx!

 

X2 on the billies, a lot of folks use those damn spacers and they're garbage, going up .85 on stock springs will stiffen the ride up a tad, some folks it is bothersome to, some don't mind, I have mine set at 1.75 on stock springs and i figure the increased cornering ability is worth the extra stiffness

 

Careful though, spacer lifts are usually pretty complicated and don't always come with instructions.

 

Bite Me!

 

Billy 5100's!!

 

Billies might a bit too rough for this application. OP, are you sure you're competent enough to install these without instructions? I know mine didn't come with any...but it was pretty simple to install.

 

883's