3" Toytec 3"front spacers; did I do this correctly?

The front still dips and I was hoping with this 3" front 2" AAL it'd be more level...

Please don't be too harsh on the ridicule if I did in fact do it wrong lol





(that isn't really Yoda in case you were wondering.. I just photoshop sometimes)

 

What are your measurements from the center of the hub straight up to the start of the fender well?

 

Not sure, I didn't do pre/post measuring

I'll check it when I get home, I don't think I have a tape in my truck at the moment.

 

I'm not positive how the front installation is supposed to look like but from looking at the picture of the truck it wasnt installed correctly. You are at least 1" to low in the front. With that kit it should be completely level.

 

My thoughts exactly.. that's why I'm here lol

 

Is that another smaller spacer sitting ABOVE the shock tower?

 

Someone will chime in and help.

 

The spacer on top of the strut tower shouldn't be there.

 

Its install wrong. See attached. directions

 

Please don't drive like this.

 

Thanks for that! I lost my install instructions and was trying to find it.

I definitely feel better about this lift now lol... will correct tomorrow!

 

I didnt even notice that the first time.

 

Been like this for quite about 7 months so far..

 

If you think about the way a truck sits on top of the suspension, that top spacer isn't doing anything up there. Take it off, put that spacer under the coilbucket.

 

It's not an additional, I just farked it up lol

 

No worries. We have all messed up a mod before. It happens.

 

At least you know what to do to fix it now. They make spacers that go on the top of the strut, that however is not one.