1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

High clearance rear - what did you use to seal up the bedside cut?

Discussion in 'Off-Roading & Trails' started by Chickenmunga, Dec 13, 2013.

  1. Dec 13, 2013 at 4:54 PM
    #1
    Chickenmunga

    Chickenmunga [OP] Nuggety

    Joined:
    Apr 10, 2008
    Member:
    #5877
    Messages:
    7,576
    Gender:
    Male
    First Name:
    Mike
    Keizer, Oregon
    Vehicle:
    08 TRD Offroad DC 4x4 with stuff
    All the normal TW BS
    I'm putting on a high clearance rear bumper this weekend. After you guys made the bedside cut, what did you do as a finish? did you just put on touch up paint, rattle can...? Hoping to get some input from the voices of experience :)
     
  2. Dec 13, 2013 at 8:19 PM
    #2
    License2Ill

    License2Ill Woke like a Coma Toyota Tacoma

    Joined:
    May 20, 2012
    Member:
    #79174
    Messages:
    2,253
    Gender:
    Male
    First Name:
    Ian
    It's a dry heat thou, AZ
    Vehicle:
    2004 SC'd 5VZ DC 5spd 4x4 TRD.GOV
    Bailing wire & Duct tape
    I rattle canned the edge and applied that self adhering door edge molding.
     

Products Discussed in

To Top