3'' Toytec Lift, preassembled with new struts and coils

Sold

 

Very Interested. I have a DCSB 4x4. I was only looking for a 2.5 in. lift because I did not want to experience any issues with front end problems. Do you think this set up would cause me any problems after the install. If they settle to something below 3, I might be alright.


what were you running them on and did you have any problems? what size springs are on them?

 

I was running and still am 285/75-16' Nitto Trail Grapplers (aggressive tread) didnt have to trim at all or do a cab mount chop. Shouldnt have any problems at 3 inches or less, just keep an eye on your CV boots. No vibes at all and was in alignment besides my right caster being slightly off. CV boots looked good, fins not touching, etc. All that on factory UCA's. Was a great looking budget lift, just need to add an aal in the back and your good to go. Not sure on the coils they are factory Sr5 4wd's. Which is what is recommended for the kit is factory springs or it was designed for that. Was a decent ride for 3 inches, smooth little more stiff on the bumpy roads but that could be my new aal as well. Great way to see if you want your truck lifted and a starting point.

 

You can always take off the spacer above the top hat and it should be at your 2.5 you are wanting.

 

Correct, totally slipped my mind! If you look at Toytec's 2.5 inch spacers its the same setup just without the top plate spacer.

 

bump

 

bump for new price $200 shipped.

 

Pm sent

 

payment sent

 

Sold!