Advice on mid travel setup

Hey what's everyone, I'm a long time reader but first time poster on tacoma world. I need some advice from you mid travel guys for my 08 tacoma. I have been doing my research and I'm planning on going with the camburg 2.5" uca kit with spindles and wheel spacers. I also want to put glassworks fenders on front and rear, so I can run 35" tires. My question is to fit 35s with this setup do I go with 4" flare with 3" rise or 6.5" flare with 4" rise? Also I will be running a pre runner bumper. I'm leaning towards 4" flare because I want to fill the space in the fenders, so it doesn't look stupid. I'm just worried that 4" flare isn't enough to fit 35s. Let me know what you guys think, any advice would be helpful.
Thanks

 

Sounds like long travel to me. I'm sure all the answer to your questions can be found in the long travel thread. I found all my answers to mid travel in mid travel thread.

 

I fit 37's at full stuff with 4" flares, but I would get the bigger flare if I had to do it over again. The small ones would be fine with an MT set up, but with the wider LT it chucks mud and cow shit down the side of the truck pretty bad.

 

Can't do spindles with 4x4 (which your sig title thing says).

 

I was fine with 35s and the 4" flare. You will be fine unless you go to 37"s.

 

The maximum size I would go with if I were you is 33"s unless you want to do a ton of trimming.