POST-Lift dimensions: Is this acceptable???

I've been talking with some local Charlotte TW members and they've offered up some assistance, if needed.

My question: After installing 5100 Billies all around w/Eibach coils (front coilover set at .85") and 1.5" Progressive AAL from Wheelers, my truck sits as follows:


Driver side front - 36 1/4" (ground to bottom of fender); 22 1/2" (center of wheel to bottom of fender)

Passenger side front - 37 1/4" (ground to bottom of fender); 23 1/4" (center of wheel to bottom of fender)

Driver side rear - 37 1/2" (ground to bottom of fender); 23 1/4" (center of wheel to bottom of fender)

Passenger side rear - 38 3/4" (ground to bottom of fender); 24 3/4" (center of wheel to bottom of fender)

Based on the ground to bottom of fender measurements, the passenger side of the vehicle 1.25" HIGHER than the driver side. From front to back - driver side = 1.25"; passenger side = 1.5"

I did purchase the trim packer from Wheelers and installed on in front driver side coilover to account for "Taco Lean," but this lean seems excessive. Especially, on the passenger's side. I took the measurements on my very flat driveway.

I don't want to exercise the generous offers to assist unless there is something really wrong.

 

What happened to the other exact same thread? Didn't get answered there after a page of replies?

 

Accept assistance, and don't add to the problem by asking for help, receiving help offers and then turning them down.