3rd gen 4runner uca help needed.

Discussion in '4Runners' started by Germ, Oct 28, 2014.

  1. Oct 28, 2014 at 1:39 PM
    #1
    Germ

    Germ [OP] Master Navigator/Zipper Operator

    Joined:
    Feb 7, 2013
    Member:
    #97026
    Messages:
    1,026
    Gender:
    Male
    Arizona
    Vehicle:
    2013 TRD OR DCSB
    Recently had a shop press in and out oem bushings on my 98 4runner. Passenger side fits perfect but the drivers side doesn't clear the mount location by a fraction of an inch. Any advice to get it to clear?
     
  2. Oct 29, 2014 at 7:32 AM
    #2
    JWaldz

    JWaldz It puts the Joe Dirt in the hole

    Joined:
    May 23, 2012
    Member:
    #79405
    Messages:
    2,020
    Gender:
    Male
    First Name:
    Waldo
    Colo Springs
    Vehicle:
    99 4Runner LTD
    Take it back to the shop and tell them to fix it. If they screw anything up make sure you don't pay a dime.

    Are you talking about the upper ball joint not being pressed in the the control arm all the way or what? A pic would help.
     

Products Discussed in

To Top