whats the name??

What is the name and part # for the molding under the front head light? I broke something that holds each of them in place. Would appreciate any help.

 

Front Bumper filler and clip

 

How did you do that? Did you pull on the inside edge to release them then keep on pulling?

 

http://tps.toyotaofdallas.com/parts/2014/Toyota/Tacoma/Pre%20Runner?siteid=214074&vehicleid=411724&diagram=8512017&diagramCallOut=22

try this link for 2014....

 

I just had a new IronBull Bumper installed and i think the retainer that holds them in were missing. I was replacing the original head light bulbs and took out the headlights since the new TorchStar Led Lights are bigger and could not get enough room to place the pin back on them. I thought it would be easier to take the Headlamps and boom something popped and now they are not on there. So i need to figure out what actually broke and needs to keep those fillers in place.

 

You might have broken the plastic tab on the end where these pieces "plug" into the fender. can you get a picture of one or both of these?

 

How are you going to secure your LED bulbs if they are too big for that small metal swing clamp to close properly?