1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

'03 Regular cab 4x4 driveshaft angles

Discussion in '1st Gen. Tacomas (1995-2004)' started by Ritchie, Mar 23, 2016.

  1. Mar 23, 2016 at 4:18 PM
    #1
    Ritchie

    Ritchie [OP] Well-Known Member

    Joined:
    Dec 24, 2012
    Member:
    #93649
    Messages:
    1,930
    Gender:
    Male
    San Diego (North County)
    Vehicle:
    RC Step side Pre-runner
    2.7 w/auto, 4WU 3 link, F & R Diamonds, ARB's F/R w/ Yukon 5.29's, Inchworm 4.7 Lefty, Deavers, ARB OBA, Schrockworks up front.
    Guys & gals,
    Looking for some help here. This request is for a stock pre runner with a 2.7 motor and auto trans.

    Can someone please use an angle finder and give me the rear 3rd pinion angle from the flange and the same for the rear output flange on the T-case?

    As it stands now, my OEM rear is @ 77 - 78 degrees but I'm unsure if that wasn't changed. I'm in the dark for the T-case as the OEM cross member was removed. The builder didn't get the OEM numbers before he cut it off.

    Any help is appreciated.

    Thank you.
     

Products Discussed in

To Top