05 Tacoma climate Control

Hello everyone I have a 05 Tacoma and the third speed on the climate Control blows almost the same as the second speed. I’ve replaced the resistor and put a new blower and also cleaned the contacts on the dial and regreased it with no change any help would be appreciated.

 

Did you replace the connector to the resistor? Take it off and look inside the end that plugs into the resistor. Chances are, one or more are discolored, darkish gray and almost fuzzy looking. Not good.
I replace mine with a kit from AutoZone. it came with the resistor a new plug for the resistor and butts places to replace the factory connector. If I recall correctly, it was under $30

By the way, welcome! Hope you like to read and spend money
There's a lot of knowledge here

 

Yes sir put a new connector soldered all my wires.. I'm wondering if its in the speed dial for the blower or its a bad wire along the harness..

 

Hmmmm, got an ohm meter? Check the continuity of the switch. Resistor too.