1999 Toyota tacoma

1999 Toyota tocamo 2.7 engine rotates will not start installed new Cam and crank position sensors used solus edge and modis scanners got no codes

 

Got spark?

 

Start checking all of your electrical connections and check all terminal grounds, trust me.

 

Just how did you reach this point?

Are you able to read the real time data??

Cranks but no start .

Miles ?

Just what have you checked ?

I would start with fuel pressure then do a compression test go from there.

 

Real time data checks good checked voltage to cam sensor 3.5 volts changed sensors because ohm was reading low checked plugs getting good spark plugs are wet with gas will check fuel pressure have to go get tester to

 

Does TDC need to be set when installing the crank sensor? Maybe your timing is off? If fuel and spark are good then maybe timing is the issue. Or grounds. Triple check grounds.

 

Grounds are good spark is good will check fuel pressure spark plugs are wet with gas and has good spark

 

When you install the crankshaft sensor there is no reason to place the engine at TDC.
The computer establishes the timing so I am thinking you might want to ask if the timing marks aligned at the Camshafts, the crankshaft and the engine at TDC. If you have fuel and spark it is because the engine computer found it acceptable to "allow' fuel and spark.