200,000 Mile Club (1st Gen Tacomas)

my 2001 has 273k had her for about a year now

 

I'm almost there 196k miles
https://youtu.be/UiFnEc6qMqU

 

1999 xtra cab
270,xxx

 

02 double cab. Currently sitting at 205k miles atm.

 

Wondering if anyone has replaced their wheel bearings (front or back) as maintenance item (versus wearing out) since we are at this type of mileage?

 

I've only replaced the rears so far but haven't touched the front yet

 

I have front bearings and seals waiting to go on as part of my next project. I'm not seeing any problems yet but figure if I'm going to be working in the area I might as well make the most out of the labor.

 

Thanks for the input guys, I might consider the front when it comes time for new Upper/Lower control arm bushings. SKF....quality stuff.

 

It's worth a shot, Napa had them in stock and is a hell of a lot closer than the nearest dealership and I didn't want to wait or pay for shipping

 

Haven't posted in a long time but figured id check in. 96' 3.4 tacoma xtracab, currently at 355,000 just did some minor frame repair at rear spring hanger. Still runs like new just dealing some rust.

 

My 01 is at 297k, my 95 is at 482k. My fathers 02 is at 200k. My 02 is just under 200k

 

Clicked over 333,333 on the original clutch today while heading home in the ‘03.

 

Bumped over 300k right before pulling into my driveway a couple days back.