1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2002 2.7l dual cat header?

Discussion in '1st Gen. Tacomas (1995-2004)' started by medikirk, Nov 13, 2010.

  1. Nov 13, 2010 at 2:17 PM
    #1
    medikirk

    medikirk [OP] Active Member

    Joined:
    Nov 10, 2009
    Member:
    #25731
    Messages:
    27
    Gender:
    Male
    First Name:
    Caleb
    North Carolina
    Vehicle:
    02 SR5 2.7l 4x4
    3" lift Deck Plate Mod Dynomax Super Turbo Muffler
    Hello all. i have been a member here a while but this if my first post. i have been researching the site for headers but can't find specifics. Is there a Tri-Y header for a 2002 2.7l with dual cats? if not which would be the best for low end/mid range power gains? DT, LCE, etc?
     
  2. Nov 13, 2010 at 7:43 PM
    #2
    Digiratus

    Digiratus Adventurer

    Joined:
    Mar 26, 2010
    Member:
    #34006
    Messages:
    23,039
    Gender:
    Male
    First Name:
    Mike
    Roaming the PNW
    Vehicle:
    The RedHead
    2002 XtraCab TRD 4x4 SCv6 AutoTrans With Lots of Mods ADS COs w/Compression Adjusters Camburg Uniball UCAs Whiteline Lower Control Arm Bushings Kartek 7" Limit Straps Plastics Guy Front Bumpstops Custom Alcan Springs +800 lbs +3" ADS 10" Stroke Triple Bypass w/Resi Rear Shocks Custom Rear Shock Relocate All-Pro U-bolt Flip w/Timbren Bumpstops 4.88 Nitro Gears ARB Front Locker ARB Twin Compressor Black 17x8 Konig Countersteer Type X 285/70r17 Falken A/T3w Gunmetal 16x8 SCS Ray10s 255/85r16 Maxxis Bighorns Limited Edition (Relentless) Elite Front Bumper Smittybilt X2O 10K Winch Diode Dynamics SS3 Sport Selective Yellow Fog Lights in the Bumper Diode Dynamics SS3 Pro 4,000 Kelvin SAE Driving Lights with Clear Lenses on the Bumper Morimoto D2S Projectors XB35 Ballasts + 4300K Bulbs Badland Sliders FrankenFab Tire Carrier Swingout bumper w/kitchen BudBuilt Front & Bellypan Skids BAMF Rear Diff Skid Dometic CFX 55im Fridge/Freezer Alpha II Hardshell RTT Badland Custom Bed Rack Denso 210-0461 105 amp alternator Dual Northstar 24F AGM batteries BlueSea 7622 ML-ACR Battery controller Peak DBI Dual Battery Voltage Monitor Magnuson MP62 Supercharger w/2.37" Pulley Haltech Elite 2000 Standalone ECU Denso 650cc Fuel Injectors Doug Thorley Headers Aeromotive Stealth 340 Fuel Pump TransGo A340F Reprogramming Shift Kit Magnaflow Hi-Flow CAT, Magnaflow 18" Muffler w/Vibrant Resonator 13WL Brake Calipers Braided Steel Brake Lines ScanGauge II OBDII Scanner Kenwood TM-71A Dual Band Ham Radio Larson 70CM/2M Antenna Uniden 520xl CB radio 3' Firestik Adjustable tip antenna Pioneer DEH-P9400BH HU Alpine Amps & Type R components (F) and coaxials (R) Wet Okole Seat Covers Weathertech Digital Liners Deck Plate Mod 1" Diff Drop Carrier Bearing Drop
  3. Nov 13, 2010 at 8:26 PM
    #3
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,530
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    X2 on the NWOR headers. Very pricey, but give the best gains. I think its the best designed header for the 2.7. IF you get them, Use an OEM Toyota gasket. Thought they say they are a "No gasket" fit, they WILL leak if you dont use one.
     
  4. Nov 14, 2010 at 4:00 AM
    #4
    medikirk

    medikirk [OP] Active Member

    Joined:
    Nov 10, 2009
    Member:
    #25731
    Messages:
    27
    Gender:
    Male
    First Name:
    Caleb
    North Carolina
    Vehicle:
    02 SR5 2.7l 4x4
    3" lift Deck Plate Mod Dynomax Super Turbo Muffler
    checked out NWOR and their description stated that the headers only go to 2001. during my research i found a thread on TW about this issue and i believe a rep from NWOR said that toyota changed the flange design for the 2.7l in 2002 and that the headers will not match up to the block. any other opitions guys?
     

Products Discussed in

To Top