2002 extra cab 4x4 2.7 frame Swap ??

I’m still driving my 02 Tacoma and am getting ready to swap the frame. I picked up a used frame a few years back out of Florida, had it blasted and powder coated, turned out really nice. The inside looks pretty good with no flaking and I plan to fluid film it.

I’ve wondered if putting holes “punched/flanged holes” in the side/inside of the frame would help keep it clean and not compromise the strength?

I’m sure I need new springs, front and rear and I know there were links on the forum of where to buy. Could someone link that for me please??? Thank you

I have equipment to lift the bed and cab and a shop to do all of this inside although I will probably be lifting both with a skid steer. I have basic tools with air and battery Milwaukee but I do not have torches, I can’t believe I don’t but I don’t. May pick those up in a week or two. I’m worried about clips for holding wiring and brake lines breaking when I try to change them. Is there a kit for this or have to order individually???

I would appreciate any and all advice I could get from you fellows on this as I’m sure I’m missing something to prepare for.

What should I plan on doing because it’s the easiest time to do it??? Another question,,, is this the most appropriate sub forum or should I put this in another? Don't want to clutter the forum up but I would like some eyes on this by hopefully someone who’s already been there. I may even try and document this in video or photos as my hillbilly voice probably isn’t that great to listen to.

Again, thanks for any and all advice!!!

 

This should help.

 

Thanks, I know there’s lots of info on the forum and I’m reading just limited on time.