2003 PreRunner

My loss may be your gain ... my son rolled the 2003 PreRunner in December and it is currently sitting in his garage. While the exterior is pretty banged up, there are still a lot of good parts. I would be willing to sell as is (he has the signed title) or he is willing to remove parts and ship. With the exception of the drivers side door panel, the interior is still in excellent condition. There are no rips, tear's or stains on any of the seats or carpets (stain on one floor mat, as shown). All window and door locks work as they should and the airbags are still in tact. All glass is still in tact with the exception of the windshield and drivers side window. Topper appears to have a crack but all glass is still in place, so I would assume it would be repairable. Less than 5000 miles on new OEM UCA's/LCA's and ball joints, aftermarket coil-overs, shocks, HD rear leaf pack, all belts and hoses, including timing belt, water pump. Fluids had been changed on recommended intervals and had been using Mobile One synthetic for several years.

True to Toyota, it still starts and drives. Can provide video upon request.

Vehicle is located in Tempe, AZ.

Please contact me if interested in the vehicle as a whole or if looking for parts.

The only item he has set a price for is the rear bumper.

Home made steel rear bumper with swing out tire carrier, two jerry can holders, high lift jack and shovel holder. Purchased from another TW member ... $750.



Upgraded stereo and speakers ... Pioneer with Bluetooth and four kicker speakers.






Interior








Suspension

 

How granular will you be parting it out? I would love to get all 4 of the door stays, the 4 retractable seat belts, (assuming they are all good) and the two gray switch blanks located in the lower forward center console/dash next to the cig lighter.

 

I am interested in the double decker center console and the head unit

 

PM sent

 

PM Sent

 

PM Sent

 

Interested in the plastic that covers the seat rails for the driver's seat if you're parting it out to that level.

 

Do you have these small plastic clips that hold the 2 vacuum clips together?

 

Interested in the driver side A-Pillar and Grab Handle. Can you send me a quote for the price with shipping to 90305? Thanks!

 

Steering wheel without airbag shipped to 76008 please.

 

Do you still have the speakers and radio?

 

Pictures of the damage? I may be interested in the entire truck

 

Hi folks ... haven't forgotten about any of you ... I'm on the road with limited access being able to get on line. I hope to have answer's for everyone by tomorrow, mid-day. Thanks for your patience.

 

PM sent

 

If you sell the sill plates that go along the door-carpet trim for the front doors I would gladly take them. Name your price shipped to MD!

 

id be interested in the topper if its still in decent condition

 

Hello I am interested in the catalytic converters if there still for sale thank you

 

I need the bracket that holds the wiring harness up directly to the right where it comes through the firewall.

 

Hell, if it’s stripped down far enough and it’s relatively rust free, I’d love to get the frame off you. I’d make the trip across the country

 

PM replies sent to everyone ... some with prices, some with questions. I have a long layover tonight into tomorrow and will be able to answer more questions in the morning. Thanks for everyone's patience.

Eric