2006 Tacoma 2WD Dual Cab 4.0 - Driveshaft vibration when accelerate

Hi everyone:

I am new in this forum and come to you with a problem I started feeling with my 2006 Tacoma. I had it since new and has driven over 121k miles on it. Just recently and for not specific reason I started feeling a vibration that looks to come from the driveshaft.

When driving I feel the vibration only when accelerating like when the driveshaft is putting pressure to the rear axle. But when I take the feet off the gas and leave the vehicle running at idle the vibration stops.

I hope someone can give e some ideas about what maybe causing this problem.

Thanks in advance
Javier

 

Welcome to the forum Javier. I'm sure someone will chime in, plenty of knowledgeable folks here

 

if it make a noise when you go from reverse to drive its the drive shaft u-pins. I had to get all 3 of mine replaced.. i think it was like 30 or 60 dollars for each.

 

Sounds like you have a bad U-joint. You can go under the car and shake it and see if it has any play in it. More then likely this is your problem.