2006 Tacoma camshaft position sensor

I broke the mounting bolt while I removing it. How do I remove the rest of the bolt? Where can I find the replacement bolt? Thanks all

 

Pull the cam sensor out.
The bolt doesn’t thread into the sensor.
And HOPE there is some bolt still sticking out.

If not, that’s going to be a tough job to remove.
You may need a right angle drill and go slow.

As for bolt size?
I’m not sure.

If the head was 12mm it was probably a m8x1.25
If the head was 10mm it was probably an m6x1.0
As for length, you can can stick a small pick down the hole and measure.
Then buy 1/8” to 1/4” smaller in length.