2007 Tacoma engine won't start.

2007 tacoma 4 cylinder 2.7 liter engine misfiring, vehicle stalled won't restart.

I replaced the plugs and coils and it still won't start. Any ideas?
(Sorry if this is the wrong place for this.)

 

Do you have fuel? Air, spark, compression?

 

Mileage?

 

Any codes?

 

Any update OP? Or did you solve it since it’s been a few hours now

 

Only for the coils

 

Yes, Yes, idk, maybe

 

Post the codes.

 

They are all p030x. Would be more specific, but somebody through away the print out I had. Wish I had my own reader. Said it had detonation in 2 and 3.

 

All spark plugs and coils replaced and the truck still won't start?

Assuming you used correct plugs gapped as per factory service manual and the coils are not some cheap Chinese crap.

Here's the factory service manual. Cover 4/6 cyl. engines.

http://www.customtacos.com/tech.old/files/05FSM/repair.html

 

Coils are duralast, only ones i could find where I'm @. Plugs came pre-gapped(.044)
I checked before install just to be sure. Thank you for the link. I'll check it out better after i fix my astros problem(s).

 

This is a shot in the dark as all "no start" discussions are, but you might also try cleaning the MAF sensor. P030x codes can be caused by dirty/defective MAF along with a long list of other things. CRC makes a product for cleaning Mass Air Flow Sensors(MAF) that costs about $6-$7 a can. Disconnect electrical connector - remove 2 screws and out comes the MAF. 2 sets of thin wires - Spray the hell out of them with the CRC; then let air dry for 30-45 mins. Reinstall. Nothing to reset.