2013 Tacoma mass airflow sensor

So I had a URD supercharger put on my Tacoma 4 cylinder. Got about 400 miles on it and check engine light came on. Mass airflow sensor. I cleaned it while waiting for new one to show up. (Oem). Check engine light for mass airflow came on again. Truck is still running perfect no problems. I installed new sensor. It made it 2 days before check engine for same sensor came on. I have gone through literally everything I can think of as far as all the connections are tight. Checked to make sure the wires that connect into ecm are tight. Just not sure where to go other than take it to Toyota. The truck has not miss a beat.so if the wires were loose or the sensor was bad it would run terrible. If anyone here can maybe give so help that would be great.

 

What is the DTC?
May not be a MAF sensor.
Check the air filter.

 

Make sure the plugs are tight and what plugs are you running?

 

What is DTC? I am defiantly not very mechanically inclined other than the basics. I can remember what plug they sent with charger kit. But they got changed out when the charger was put on with URD plugs.just looked denso iridium power plugs

 

So I put on a new air filter box with a new air filter.