2017 Tacoma (H) Key - Compustar CM7200 Install

Hi Guys,

Posted over on 12volt but also looking for Tacoma specific experience and input.
2017 Tacoma SR 4cyl/Manual Trans (H)-Key

Looking to install my Compustar CM7200 RS with Alarm etc, removed from my previous car. Have already bought an ADS-USB and flashed both the brain(V3.25) and Blade(AL-DL-TL9). I'm really hoping for some guidance on this, as I'm feeling really close but not confident just yet. My questions are:

• Does the Idatalink diagram cover every vehicle connection needed, if not, which ones would still be left?
• The SR Trim level does not have any form of Autolights that I'm aware of. Is the pictured relay still needed?
• The main Compustar harness is all large gauge, however the ignition switch is a mix of large and smaller gauge wire. Is there an issue connecting say 2nd Ignition Large directly to the smaller OEM wire(after setting proper jumper)?
• What is the best location you would you advise to tap for the 12v input(s)?
• Best way to wire/bypass the clutch switch?

Parts list
-CM7200 V3.25
-ADS BL-AL
-Pro 901 Remotes
-DAS Sensor
-Siren

Thanks!

 

Posted in the right section..

 

What key fob did you end up getting with this or end up using?