285 75 16 Fitment with 5100 Bilstein in the front

Hey I was just wondering if anyone had this set up and didn't have to do a CMC. Thanks.

 

would like to know the answer also..

 

Cmc like mutha fawker pinch weld beating

 

Yes most shop charge about 150 to do proper cmc

 

Fuck that noise....i hacked mine off with a sawzall.

 

Did you weld a plate on your cut cause if you get in an accident and you are seriously injured the insurance will blame alot of it on you for modifying the integrity of the frame

 

They always find someway not to pay.

 

Do you seriously think they will even know to look at it? Possible, yes. Probable, no.

 

Just got everything on (Bilstein 5100 at the highest setting in the front, 1 inch block in the back and 285/75/16 Falken Wildpeak on the stock rims). The only problem that I am having is at full turn the sidewall of the tire rubs the upper control arm. Other than the rubbing on the UCA it is no where near touching on the inside of the fender on the front or the rear. Just thought I'd update so anyone else who was wondering would know.

 

Just do the cmc! It's not expensive, and it let me fit 305's.

 

I am looking at the same tire size and curious of anyone has experience with this size in the stock spare tire area?

Any problems with gearing?