1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

3rd Gan Fox Pro Tacoma setup work on 4th Gen 4Runner

Discussion in '3rd Gen. Tacomas (2016-2023)' started by Layzboy, Dec 21, 2023.

  1. Dec 21, 2023 at 12:26 PM
    #1
    Layzboy

    Layzboy [OP] Well-Known Member

    Joined:
    Nov 19, 2006
    Member:
    #262
    Messages:
    471
    Gender:
    Male
    First Name:
    Rob
    Glendale,AZ
    Vehicle:
    99 Rerunner TRD Off Road Sunfire Red Pearl
    Just gettin started
    I was wondering if 3rd Gen Tacoma Fox Pro setup would work on the 4th gen 4runner. The 5th gen Bilstein 4runner fronts have to be grinded a bit to fit the LCA's and rear upper shock mounts you have to bore the upper frame hole which I Don't want to do. Not sure about 5th gen Runner Fox Pro setup but assume it would be the same. I have found a few deals on the Taco Fox setup and would like to replace my Crap 5100's as the front shock LCA bushing are shot. Dont have a lot of Cash at the moment. I hear the stock Bilsteins only need rear lower bushings swapped to be a direct swap. Thanks in advance for any help
     
    Last edited: Dec 21, 2023

Products Discussed in

To Top