3rd gen low pro bed rack

I'm selling my bed rack that I built. It's a steel rack designed to fit over my retrax bed cover. It is plenty strong and has a hilift mount on the left side. The rack sits about 4" above the bed. I built it with the intention of putting a rtt on it but having the tent sit low enough (at or below roof level) to keep wind noise down when driving. It can be easily removed it a few minutes if you need to put large items in the bed of your truck. I can help install it if you want.

Located in Prescott, AZ. Asking $250.

 

Are those rails along the top of the bed sides part of the rack or how exactly does this mount?

 

The rails on the top are a part of the bed cover. The rack mounts on brackets that are under those rails and bolted to the bed where the factory trifold cover mounts to.

 

Would those work with an access tonnosport rollup vynl cover. The rails hug the bed sides like your does. It goes underneath like an L bracket and fastens to the rails also?

 

I believe it will work with any cover minus a trifold since the height is low. My brackets don't mount to the rails. Here's a pic of how they mount. This pic is build progress so it's obviously not complete. But the bracket sits under the top rail of the cover and bolts to factory holes in the bed.