1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

3rd gen sPOD 6 Switch setup?

Discussion in '3rd Gen. Tacomas (2016-2023)' started by PandaTRDPro, Jun 27, 2017.

  1. Jun 27, 2017 at 4:36 PM
    #1
    PandaTRDPro

    PandaTRDPro [OP] Member

    Joined:
    Jun 19, 2017
    Member:
    #221935
    Messages:
    12
    Gender:
    Male
    Vehicle:
    2017 Tacoma TRD Pro
    Dual ARB Air Compressor, Pelfreybilt Steel Skid Plates Front to Back, Pelfreybilt Top Plated Rock Sliders, RCI Rear Steel Bumper w/ Rigid SQ Back up Lights. Pending: RCI Aluminum Bed Rack sPOD 6 switch Tepui RTT
    Anybody running the 6 switch panel sPOD on their 3rd gen tacoma? If so please post some pictures bc I'm trying to figure out where to put my switches in my rig...I also don't have the sunglass holder in my Pro so thats not an option either. I tried looking into the cubby on the left side of the steering wheel but it is still a tad too small to fit all 6 switches in there.
     

Products Discussed in

To Top