1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Adding tie down points to bed

Discussion in '1st Gen. Tacomas' started by Alpha Q Up, Nov 29, 2011.

  1. Nov 29, 2011 at 2:51 PM
    #1
    Alpha Q Up

    Alpha Q Up [OP] Well-Known Member

    Joined:
    Aug 18, 2011
    Member:
    #61921
    Messages:
    2,275
    Gender:
    Male
    First Name:
    Ruben
    San Jose
    Vehicle:
    2003 4WD DC Tacoma
    I have two tie down points in the bed of my truck. (by the gate)

    I'm not sure if there should be two more by the cab, but i have a roll out cover that may be blocking them.

    my question, has any one had any success in adding new tie down points to the sides or mid way onto the bed?
     
  2. Nov 29, 2011 at 4:03 PM
    #2
    Blackdawg

    Blackdawg Dr. Frankenstein

    Joined:
    Dec 31, 2010
    Member:
    #48500
    Messages:
    50,083
    Gender:
    Male
    First Name:
    Monte
    Wyoming/St. Louis
    Vehicle:
    96.5 FrankenTaco & 03 Stock dbl cab
    BFG KM2 33x12.5 tires, Wheelers Type B rims, Allpro 1.5'' Wheel spacers w/extended thread lug nuts 2 Alpine 10'' Type Xs 2 Kicker 6X9s 4 Sony 5 1/4s Pioneer 4100 HU Sway bar removed 4 Hella 500 HIDs Frankenstein Leaf packs 1'' lift shackles Eibach coils 5100s front 10'' 5150s rear BAMF BPV bracket Deckplate mod Elite Front bumper Magnaflow 14'' muffler Elite Off Road Rear bumper with Tire gate with jerry can and fold down table, BAMF sliders, Custom Homemade Bed, rack/roof rack, CVT Mt. Shasta Roof Top Tent, 20lb CO2 tank, BAMF diff skid custom front skid, GM CS144 140 amp alternator Blitzpro 21s HAWK side LEDs Blitzpro Custom made side mirror lights, LightForce 240 Blitz llights, Piaa 510 ION fogs, XRC8 Winch w/in cab controls,
    Like the ones that are 3/4 the way up the bed?? I bet your cover is just covering them.

    If you go rid of the plastic liner then you could just bolt some to the bottem corners im sure.
     
To Top